Yahoo Malaysia Web Search

Sign In

Search results

  1. forums.ni.com › t5 › LabVIEWA simple example for LabVIEW to write to USB-6501 outputs? - NI...

    May 19, 2011 · I've just purchased a USB-6501, and am just looking for a simple example for Labview to write to a few USB-6501 outputs, from LabVIEW 8.2. The few references I've found on the NI site tell me to go through "Find Examples", but even by following the references exactly, it doesn't lead me to anything about the USB-6501 or anything like it!

    • usb-6501 help

      Plug in your 6501 to your PC, run MAX, find the 6501, and...

    • usb 6501

      i am new to labview and want to develop an vi to measure...

  2. Videos

    View all

  3. download.ni.com › support › manualsNI USB-6501 User Guide - National Instruments

    The National Instruments USB-6501 is a Full Speed USB 2.0 device that provides 24 DIO channels and a 32-bit counter. This user guide describes how to use the device. For specifications, refer to the NI USB-6501 Device Specifications document available at. ni.com/manuals.

  4. forums.ni.com › t5 › Digital-I-ORe: USB-6501 - cannot find a Labview basic example - NI Community

    Feb 1, 2010 · The driver has to be installed after the installation of LabVIEW. After the installation, make sure that the device is listed in MAX under 'DAQmx Devices'. If it's not listed, then your installation is still not correct. To look for examples for LabVIEW, go to Help>Find Examples.

  5. forums.ni.com › t5 › LabVIEWUSB 6501 driver... - NI Community

    Dec 22, 2016 · So I am trying to use the USB 6501 with Labview on an older XP machine with SP 3. Under MAX, the 6501 shows up as "dev1". I have read through and watched a video that talks about updating the firmware on the NI USB-6008/6009 with the DAQmx Base Driver 3.x.

  6. forums.ni.com › t5 › LabVIEWni USB 6501 - NI Community

    Jan 21, 2014 · I am new to NI. I have the basic experience of labview programming. I want to buy NI USB 6501 for my project. I have installed NI DAQmax for this. Before buying, I want to clarify the doubts. 1. I want to enable the indicator in the fornt panel whenever the proximity sensor (digital) is sensed through the USB 6501 device. 2.

  7. forums.ni.com › t5 › LabVIEWusb-6501 help - NI Community

    Jan 24, 2023 · Plug in your 6501 to your PC, run MAX, find the 6501, and create a Test Panel. Here you "define a task", say, Digital Output. You define your channels (say Port 1, Lines 0..4).

  8. forums.ni.com › t5 › LabVIEWusb 6501 - NI Community

    Sep 19, 2011 · i am new to labview and want to develop an vi to measure speed of bldc motor from hall pulse i am using ni usb 6501with 34 ports are there any